Instruction Guide for AVB2SH20 with 19" x 36" |
||||||||||||
 |
 |
|||||||||||
|
Remove endcaps & slide extrusion into center of
the channel and back of base.Tighten with allen key and replace endcaps.
|
Measure the length of the banners and then slide each
IH clamp down the middle channel of the extrusion and screw into place.
|
|||||||||||
 |
 |
|||||||||||
|
Line up each banner rail with each IH clamp and place
the tear drop side up. Slide onto clamp.
|
Screw banner rails securely onto clamp.
|
|||||||||||
 |
 |
|||||||||||
|
Slide the banner into channel of both top & bottom
banner rails.
|
Place endcap onto each banner rail.
|
|||||||||||
 |
 |
|||||||||||
|
Slide AV Shelf through top into desired position.
|
When shelf is in desired position, tighten each screw
with an Allen wrench.
|
|||||||||||
 |
 |
|||||||||||
|
If using standard mount, place in desired location
and tighten each screw.
|
If using a tilting mount, twist rod until mount is
in desired position and place mount down into pole.
|
|||||||||||
 |
 |
|||||||||||
|
Tilt mount to desired angle and tighten screws to
secure.
|
Tighten top screw to secure rod in place.
|
|||||||||||
 |
||||||||||||
 |
||||||||||||
|
After attaching bracket to television(s) with provided
screws, line up holes with mount(s) and slide into place.
|
Finished Product.
|
|||||||||||
|
|
||||||||||||
